![]() It is on the CB band,they never did work as good as present day systems,Some truck driver will key up and put you down.By the time you rewire the servo connectors and I assume you are going to replace the batterys you will have a good amount of money involved in a marginal system. I start a new theater for the old remote control systems (vintage). PUT IT ON THE SHELF AND KEEP IT AS A MOMENTO OR SELL IT TO Vintage & Old Timer Radio Control Systems. I was a World engines service center and serviced and tuned many of these units years ago Lot NOS Switchcraft Switches Reed Transmitter Etc R/c Vintage model airplane. If you use all three wire sevos you will not need the white center tap wire at all.The receiver uses 4.6 volts just like the newer receivers The servos are the only part that require the white center tap wire. uetooth player remote control, air condition remote control,projector main borad. Three wire servos will work OK with the Controlaire system.Just match the wires Red toRed Black to Black and IGNORE THE WHITE WIRE You will not need it for three wires servos The remaining wire whatever it's color is the signal so match it up to the color left on the receiver servo wires.The white wire was the center tap of the battery and was used because the S4servos had 2.5 volt motors and they needed it. Remote Control For LENCO SR-05BT DR-05BT Bluetooth Retro Radio FM Audio.
0 Comments
Leave a Reply. |